TPM - Wash Solvent - 20L CYBER MONDAY Mark Point Collage

Mark Point Collage

Maximum reach: 780 x 900 mm

two new pins are placed close to the reset pin

it keeps the heat inside the hot end and off the print

Dimensionally stable

TPM - Wash Solvent - 20L CYBER MONDAY Mark Point CollageWash Solvent TPM Wash Solvent (Tripropylene glycol monomethyl ether) is a non flammable, low odor solvent that can be used to clean and dissolve uncured resin on SLA DLP 3D printed parts. TPM has a lower evaporation rate than IPA and washes about three times as many parts as IPA before it needs to be replaced. * Compatible with Formlabs Finish Kit, Form Wash and Form Cure * 20 litres ! ATTENTION ! TPM is not currently certified for use with Formlabs